Antec P182 Manuel d'utilisateur

P180/P180B/P182/P182SEUser’s ManualManuel de l’utilisateurAnwenderhandbuchManuale per l’operatoreManual del usuarioপᡅ䂀ᯢ᳌

1At Antec, we continually refine and improve our products to ensure the highest quality. So it’s possible that your new case may differ slightly from

24. Loosen the two thumbscrews holding the plastic structure. Slide the large piece all the way to the rear of the case to fully extend the opening an

33. Power Switch (labeled POWER SW) connects to the PWR connector on the motherboard.4. Power LED (labeled POWER LED) connector is located behind the

4Pin Assignment for Front Panel IEEE 1394 ConnectorConnecting the Audio Ports (AC’ 97 and HDA)There is an Intel standard 10-pin AC’ 97 connector and a

5dampening ability of the silicone grommets. Note: Always mount the HDD with the thicker side of the silicone grommets facing up.5. Slide and lock the

6A fan-controller regulates the fan speed by varying the voltage to it. The voltage may start as low as 4.5V to 5V. Connecting a TriCool™ set on Mediu

7The Middle Fan – The middle fan is especially designed to cool the VGA card and even a dual VGA card configuration. In this case the HDD cage becomes

Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538USAtel: 510-770-1200fax: 510-770-1288Antec Europe B.V.Sydneystraat 333047 BP RotterdamThe Netherlandste