Antec Multimedia Station Elite Guide d'installation télécharger pdf (Page 4)

4. Connect the 3pin standby power cable from the 24-pin

power adapter to CN1 of the internal receiver. This connector

is shaped so that it only fits one direction.

5. Connect the wires from CN2 to the power switch (usually

labeled PWR SW) connector on the motherboard. You may

need to refer to the motherboard manual to determine the

correct location. Polarity (positive and negative) does not

matter for switches.

6. Connect the cable from the PC power switch (usually la-

beled POWER SW) to CN3 of the internal receiver.

1 2 3 4 5 6 7 8 9 ... 37 38

Pas de commentaire

Antec Multimedia Station Elite Guide d'installation Page 4