Antec Three Hundred Two Manuel d'utilisateur télécharger pdf (Page 12)

2.7 Internal 2.5” Device Installation

There are two 2.5” drive mounting locations in the Three Hundred Two: on the back of the motherboard

tray and at the bottom of the case.

To install on the back of the motherboard tray:

1. Remove the side panels as described in Section 2.2.

2. Secure your drive with the 2.5” screws provided (C in Section

1.3). Your drive will attach on the back of the motherboard

tray, with screws affixing from the front of the tray.

Note: The motherboard should not be installed when installing your 2.5” device in this location.

To install at the base of the case:

1. Remove the left side panel as described in Section 2.2.

2. Secure your drive to the base of your case with the 2.5” screws provided (C in Section 1.3).

Align your drive’s holes with the drive bay holes.

Secure your drive with the provided 2.5” screws.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Pas de commentaire

Antec Three Hundred Two Manuel d'utilisateur Page 12