Antec II Manuel d'utilisateur Page 1

SONATA IIUser’s Manual Manuel de l’utilisateurAnwenderhandbuch Manuale per l’operatoreManual del usuario

Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538Tel: 510-770-1200Fax: 510-770-1288Antec Europe B.V.Sydneystraat 333047 BP RotterdamThe NetherlandsTel:

2At Antec, we continually refine and improve our products to ensure the highest quality. So it'spossible that your new case may differ slightly f

3the red voltage switch setting on the power supply. It should match your local voltage (115V for North America, Japan, etc. and 230V for Europe and m

INSTALLING THE MOTHERBOARDThis manual does not cover CPU, RAM, or expansion card installation. Please consult your motherboardmanual for specific moun

5headers so that the blocked pin fits over the missing header pin.Note: Please check your motherboard manual for your USB header pin layout and make s

2. Microphone Power: Connect the MIC-BIAS connector to this pin.3. Ground Pin: Connect the AUD GND connector to this pin.4. Front Right Speaker Out Pi

7COOLING SYSTEM The Rear Exhaust TriCool fanThe Sonata II comes with one 120mm TriCool fan preinstalled with silicone grommets in the rear.Note: The d

81. If you removed the tube under setting up, insert the notches on the tube into the tabs on thecase and slide the tube towards the bottom of the cas

To install the 80mm VGA fan:1. Remove the two screws holding the silver metal stripe to the air inlet that connecting to the Tube of the ACAG. Set the