Antec Quiet Computing Two Hundred Manuel d'utilisateur télécharger pdf (Page 5)

ARDWARE

NSTALLATION

UIDE

2.1

ETTING

1. Place the case upright on a flat, stable surface with the

rear of the case facing you.

2. Remove the side panels by first removing the

thumbscrews at the rear of the case. Then, grip each

panel at the top and bottom and slide it toward the rear

of the case until it detaches from the chassis.

3. To remove the front bezel, locate the three plastic tabs

on the left side of the bezel. They fasten the front bezel

to the metal chassis. Release the tabs from the top down

to release the bezel. Swing the bezel open to about 45°

and gently lift the bezel upward, and it will come off

easily. Set the bezel in a safe place.

Note: Do not use your fingernails to pry or lift the panels.

2.2

OWER

UPPLY

NSTALLATION

1. With the case upright, place the power supply on the

bottom of the case.

Note: Power supplies with fans on the bottom of the

power supply will need to be mounted so that the

fan is facing the top of the case. The Two Hundred

provides mounting holes for power supplies with

standard mounting layouts to be installed upside

up or upside down.

2. Push the power supply to the back of the case and align

the mounting holes.

3. Attach the power supply to the case with the screws

provided.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Antec Quiet Computing Two Hundred Manuel d'utilisateur Page 5