Antec CS-52553CB Manuel d'utilisateur

Nine Hundred User’s ManualManuel de l’utilisateurAnwenderhandbuchManuale per l’operatoreManual del usuarioপᡅ䂀ᯢ᳌

1At Antec, we continually refine and improve our products to ensure the highest quality. So it’s possible that your new case may differ slightly from

23. Remove the thumbscrews from the other side panel and open it by sliding it towards yourself. Place the screws carefully aside. Inside the case is

33. Connect the Power Switch (labeled POWER SW) to the PWR connector on the motherboard.4. Connect the Hard Drive LED (labeled H.D.D. LED) to the HDD

44. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin.5. Front Left Speaker Out Pin: Connect the FPOUT-L connector to this pin.

54. Mount the hard drive into the drive cage and fasten it using the screws provided in the tool bag.5. Repeat the same procedure for the other HDD(s)

6The Rear Exhaust TriCool™ Fan There is a 120 x 25mm TriCool™ fan preinstalled at the rear of the case. The fan is installed so the air will be blown

7The Side Fan — the Side fan is there to enhance VGA cooling. Just drop a fan into the bracket on the side panel so that air is blowing into the case.

Antec, Inc.47900 Fremont Blvd.Fremont, CA 94538USAtel: 510-770-1200fax: 510-770-1288Antec Europe B.V.Sydneystraat 333047 BP RotterdamThe Netherlandste